Alarm information:
Cause |
Configuration error detected in the file DNSch.CFG |
<ch> |
CAN channel number (index starting from 0) |
<code> |
Error code: •-1 = No board found •-2 = Unable to load LOADER code (<subcode>): -2 = Error opening file (PFLMvvrr.O86) -3 = Illegal file length -4 = No start (att. 1) -7 = No start (att. 0) -14 = Memory allocation error -20 = Failed startup test 1 CAN.INT.nCH -21 = Failed test 2 of startup CAN.INT.nCH -22 = Failed test 3 of startup CAN.INT.nCH -23 = Failed test 4 of startup CAN.INT.nCH •-3 = Unable to load EXEC code. (<subcode>): -2 = Error opening file (executor) -3 = Illegal file length -5 = Block timeout (att.1) -7 = No startup (att.0) -8 = Block timeout (att.0) -10 = Never loaded -11 = Illegal slot -14 = Memory allocation error -24 = Failed startup test 1 CAN.INT.nCH -25 = Failed test 2 of startup CAN.INT.nCH -26 = Failed test 3 of startup CAN.INT.nCH -27 = Failed test 4 of startup CAN.INT.nCH •1 = DNSch.CFG file not found •2 = Unknown command in line:<line> •3 = Wrong parameter in line:<line •4 = Command in wrong place -line::<line> •5 = Missing offset number -line:<line> •6 = Missing mandatory information (<subcode>): 0 = No block or WS_ID defined n = Block number whose input length is different from output length (n>1) •7 = Multiple definition -line:<line> •8 = Non-contiguous data block_to_rbx (<subcode>): n = Write buffer block number without contiguous data (block_to_rbx) •9 = Non-contiguous data block_to_rbx (<subcode>): n = Read buffer block number without contiguous data (block_from_rbx) •10 = Overlap of data in block_to_rbx (<subcode>): n = Write buffer block number with overlapping data (block_to_rbx) •11 = Data overlap in block_from_rbx (<subcode>): n = Read buffer block number with data overlap (block_from_rbx) •12 = Memory allocation error •13 = Error reading DNSch.CFG file •14 = Board configuration error •15 = The mandatory PROFIBUS_ADDRESS is missing •17 = Too many boards found •18 = Diagnostics issued only when using Ethernet/IP if communication level configuration failed (e.g., exchange buffer size not congruous) or switch on connection timeout expired |
Output condition |
|
Effect |
CANopen communication not enabled |
What to do |
Correct the DNSch.CFG file according to the code type |
Alarm mask |
am[49].24 |
Alarm par prominent |
No |
Alarm type |
|
Notes |
|